Home About Product Contact Terms

Simco Coatings Inc.
211 Gunther Ln.
Belle Chasse, LA 70037
Office: 504.393.9455
Toll-Free: 866.95.SIMCO
Fax: 504.433.1406

For more information or purchase request

Email: sales@simcocoatings.com

Legal/Privacy Info.

Description: Fastrack-1952 is a high solids, low VOC, ready mixed, single component, water borne airfield and traffic marking paint. The paint is intended for application on such traffic bearing surfaces, portland cement concrete, asphalt and previously painted areas of these substrates. The paint may be used either alone or to bind reflective beads.

Suggested Uses: Suitable to be used on concrete, bituminous, brick or stone surfaces of airfields, highways, bridges, tunnels, streets or parking lots when applied at a proper wet film thickness by means of traffic striping equipment designed for water based paint.

The White and Yellow Paint stripes should preferably be reflactorized for night visibly by adding glass beads.

Conformance: This paint conforms to U.S. Govt. specification No. TT-P1952D

Technical Data

Color and Finish: White, Yellow, and Black; Lustreless (Non-Gloss)
Consistency, Kreb Units (KU): 80-90 @ 77 F
Percent Volume Solids:

Yellow/White - 60%
Other Colors - 58%
Weight per Gallon: 12
Volatile Organic Compounds (VOC): 1.25 Lbs./Gallon or 150 grms./ltrs.
Recommended DFT: 10 Mils (250 Microns)
Theoretical Coverage @ 10 Mils: 60-90 sq. ft./gal or 8.4 sq. meter/gal.
Dry Opacity:

White & Colors - .92
Black - 1.0
Directional Reflection of White Paint: 85%
Flash Point: N/A
Recommended Thinner: Fresh Water
Shelf Life: 1 year
Drying Time:
To no pick up: 10-15 minutes
To Dry through: 1-2 hrs.

1. Steam clean old concrete surfaces to remove all dirt, grease, oil and other foreign matter.
2. Allow it to dry overnight.
3. New concrete must be cured at least 14 days and must be free of surface moisture.
4. Apply to clean concrete only. Do not use on concrete containing membranes or curing agents.

Apply under Normal conditions ie. 50 % relative humidity, moderates temperatures and slight breeze.

Safety Precautions:
(A) Use normal precautions such as gloves, facemasks.
(B) Adequate ventilation must be maintained.
(C) Explosion proof lights & electrical equipment.
(D) Non-Sparking shoes & tools for workers in area.
(E) This product contains flammable materials. Forbid all flames, smoking and welding in work area.
(F) Avoid breathing of vapor, contact with skin or eyes. If product comes in contact with skin or eyes, wash thoroughly with water and obtain medical attention.

The technical data listed herein has been compiled for your convenience and guidance, and is based upon our experience and knowledge. However, since we have no control over the use of this information of this product, no warranty expressed or implied, is intended or given. Simco Coatings, Inc. assumes no responsibility whatsoever for coverage, performance, or any other damages, including injuries resulting from use of this information or of products recommended herein.

Copyright 2001-2012 Simco Coatings Inc. All rights reserved.