Home About Product Contact Terms

Simco Coatings Inc.
211 Gunther Ln.
Belle Chasse, LA 70037
Office: 504.393.9455
Toll-Free: 866.95.SIMCO
Fax: 504.433.1406

For more information or purchase request

Email: sales@simcocoatings.com

Legal/Privacy Info.

Description: One component high solids, Phenolic modified corrosion inhibitive lead and chromate free primer fast set to touch time. Excellent paint touch up primer / undercoat. Use over alkyds to upgrade system. Also suitable under Epoxies, Polyurethane and Chlorinated Rubber Finishes.

Recommended Uses: Recommended to be used on just about any paintable surface as an undercoat. Also can be used for priming structural steel, bridge, metal roofs and storage tanks in moderate chemicals environments.

Technical Data

Generic Type: Modified phenolic alkyd with rust inhibitive pigment
Color: White, Lt. Gray, Reddish Brown, Yellow
Flash Point: 80 F
Shelf Life: One year (subject to re-inspection)
Solids by Weight: 62.0%
Solids by Volume: 43.0%
Weight per Gallon: 12.5 0.2
Recommended DFT: 1.5 - 2.0 mils
Theoretical Coverage: Approx. 700 sq.ft. / gal. @ 1 mil. DFT.
Dry Temp. Resistance: 200F
Drying Time @ 75 F:
To touch: 15-20 minutes
To handle: 30 minutes
To Topcoat: 2 hours
Recommended Thinner: Universal Thinner

Surface Preparation:
Prior to application of the primer/under coater, all surfaces to be painted must be clean, dry and free of all dirt, peeling paint, rust, oil, grease, wax and all other contaminants.

Fiberglass: Over bare Fiber Glass, wash with soap, ammonia and water, let dry, then clean thoroughly with a de-waxer. Sand all Fiber Glass surfaces with 100-150-grit sandpaper and thoroughly clean off sand powder.
Old Paint: Sand with 120-200 grit sand paper and thoroughly clean the sand powder.
Steel: All surfaces must be clean, dry and free from loose rust, scale. For best results abrasive blast SSPC-SP6 commercial.

Application Data:
Brush, roller, spray.

Safety Precautions:
(A) Use normal precautions such as gloves, facemasks.
(B) Adequate ventilation must be maintained.
(C) Explosion proof lights & electrical equipment.
(D) Non-Sparking shoes & tools for workers in area.
(E) This product contains flammable materials. Forbid all flames, smoking and welding in work area.
(F) Avoid breathing of vapor, contact with skin or eyes. If product comes in contact with skin or eyes, wash thoroughly with water and obtain medical attention.

The technical data listed herein has been compiled for your convenience and guidance, and is based upon our experience and knowledge. However, since we have no control over the use of this information of this product, no warranty expressed or implied, is intended or given. Simco Coatings, Inc. assumes no responsibility whatsoever for coverage, performance, or any other damages, including injuries resulting from use of this information or of products recommended herein.

Copyright 2001-2012 Simco Coatings Inc. All rights reserved.