Home About Product Contact Terms



Simco Coatings Inc.
211 Gunther Ln.
Belle Chasse, LA 70037
Office: 504.393.9455
Toll-Free: 866.95.SIMCO
Fax: 504.433.1406




For more information or purchase request

Email: sales@simcocoatings.com

Legal/Privacy Info.
SIMVAR-832
MARINE SPAR YACHT VARNISH


Description:
A clear marine varnish based on wood oil and phenolic resin for interior and exterior use. Dries to a smooth, lustrous transparent finish.

Principle Characteristics:
- A high quality weather resistant clear varnish with excellent gloss.
- Good resistance to salt and fresh water.
- Good scratch and abrasion resistance.

Technical Data

Weight/Gallon: 7.45 Lbs
Solids by Volume: 45 1%
VOC: 3.20 lbs./gallon (380 grams/liter)
Flash Point: 104F (Min.)
Shelf Life: One year (subject to re-inspection)
Recommended DFT: 1.0 Mils
Theoretical Coverage: Approx. 650 sq./ft. @ 1.0 mils thickness
Drying Time @ 75 F:
To touch: 3 hours
To recoat: 16 hours
Recommended Thinner: T-100 Paint Thinner

Surface Preparation:
The surface to be varnished must be dry and free of wax, grease and dirt. Varnish will not dry on a waxed surface. Remove loose and scaling film and dull the gloss on previously varnished surfaces with a light sanding. Remove all dust with a clean cloth dampened with paint thinner and allow to dry for a few minutes.

Application Data:
Brush or spray. Apply two or more coats of Simvar-835 Spar Varnish. If using a brush, brush out well to avoid "puddling"

Sealed Surfaces: Apply one or two coats of Marine Spar Varnish as required.

Thinning:
Thin all but the finish coat of Marine Spar Varnish with half a pint of paint thinner per gallon. Use the finish coat as it comes from the can.

Drying Time:
Marine Spar Varnish will dry in four to five hours. It may be recoated in 24 hours under normal conditions. It may be rubbed in 24 hours.

Warning:
CONTAINS PETROLEUM DISTILLATE. Harmful if swallowed. Causes irritation. Vapor harmful. Combustible. Keep out of reach of children. Keep away from heat, sparks, and open flames. Do not take internally. Avoid contact with eyes and skin, and breathing of vapor or spray mist. Wear an air-supplied mask when applying in enclosed areas. Use with adequate ventilation. In case of eye contact, immediately flush eyes with plenty of water for at least 15 minutes. Call a physician.

Non-Warranty:
The technical data listed herein has been compiled for your convenience and guidance, and is based upon our experience and knowledge. However, since we have no control over the use of this information of this product, no warranty expressed or implied, is intended or given. Simco Coatings, Inc. assumes no responsibility whatsoever for coverage, performance, or any other damages, including injuries resulting from use of this information or of products recommended herein.

Copyright 2001-2012 Simco Coatings Inc. All rights reserved.